Repetier Host Pause At Layer. i really don't want to have to reprint the piece (looking at about a 15 hour print), so i'm wondering if there is a way to start a new. i saw there is a m25 that will pause an sd print, but this is to be sent to the running machine via host software, not added to. Just though a great feature would be the ability. in the gcode editor go to the layer start (select layer number and press button). Then simply insert @pause sitch. typical reasons for a pause are switching filament type or modifications on the printing object like adding nuts bevor enclosing it in filament. i just started using the @pause command so i can change filament at a crucial layer. not sure if slicer like curaengine support this, but if it is possible to add some custom command, like @pause, after each layer.
from www.youtube.com
typical reasons for a pause are switching filament type or modifications on the printing object like adding nuts bevor enclosing it in filament. Then simply insert @pause sitch. i really don't want to have to reprint the piece (looking at about a 15 hour print), so i'm wondering if there is a way to start a new. not sure if slicer like curaengine support this, but if it is possible to add some custom command, like @pause, after each layer. i saw there is a m25 that will pause an sd print, but this is to be sent to the running machine via host software, not added to. i just started using the @pause command so i can change filament at a crucial layer. in the gcode editor go to the layer start (select layer number and press button). Just though a great feature would be the ability.
Repetier Host Advanced YouTube
Repetier Host Pause At Layer i saw there is a m25 that will pause an sd print, but this is to be sent to the running machine via host software, not added to. in the gcode editor go to the layer start (select layer number and press button). i saw there is a m25 that will pause an sd print, but this is to be sent to the running machine via host software, not added to. Just though a great feature would be the ability. i just started using the @pause command so i can change filament at a crucial layer. Then simply insert @pause sitch. i really don't want to have to reprint the piece (looking at about a 15 hour print), so i'm wondering if there is a way to start a new. not sure if slicer like curaengine support this, but if it is possible to add some custom command, like @pause, after each layer. typical reasons for a pause are switching filament type or modifications on the printing object like adding nuts bevor enclosing it in filament.
